User manual

37
Connect the water inlet hose as described under the paragraph “Water
inlet”.
Where to install
Important! The appliance must not be used in a room where there is a
danger of frost. Frost damage or impaired operation! Frost damage is
not covered by the warranty.
• The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpets or on soft floor cov-
erings.
• The surface on which the appliance is to be installed must be clean
and dry and free from coverings that move, so that the appliance
does not slide.
• If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.
Making the appliance level
3 Automatic foot: The rear foot on the left-hand side of your washing
machine is built as a shock absorbing foot, which is why the appliance
gives in the back left-hand corner if put under load. The automatic foot
guarantees that the appliance does not move even at high spin speeds.
Basically the automatic foot does not need to be set.
The four feet of the appliance are
pre-adjusted.
Large degrees of unevenness can be
compensated for by individually ad-
justing the height adjustable screw
feet.
Use the special spanner supplied to
do this.
Important! Do not use pieces of
wood, cardboard or such like to lev-
el out unevenness in the floor, but
adjust the height adjustable screw
feet instead.