User manual

Problem Possible cause Possible solution
The appliance fills
with water and
drain immediately.
The end of the drain
hose is too low.
Make sure that the drain hose is
in the correct position.
The washing re-
sults are not satis-
factory.
The detergent you used
was not sufficient or cor-
rect.
Increase the detergent quantity
or use a different one.
You did not remove the
stubborn stains before
you wash the laundry.
Use special products to remove
the stubborn stains.
Incorrect temperature
was set.
Make sure that you set the cor-
rect temperature.
Too much laundry load. Decrease the laundry load.
The drum is empty
and the display
shows there is
some weight in (J).
It is necessary to set a
tare.
Press button
1
to deactivate
the appliance and to activate it
again.
The drum is full
but the display
shows 0.0 kg (J).
You loaded the laundry
before to activate the
appliance.
Press button
1
to deactivate
the appliance. Empty the drum
and obey to the necessary steps.
(Refer to 'Loading the laundry')
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
32
www.aeg.com