User manual

Select the TIME SAVING option (button 6)
The appliance proposes by default the washing cycle for normally soiled laundry. The
washing cycle time can be reduced by means of this button.
This option can be selected with the washing programmes for COTTONS, SYNTHETICS and
DELICATES.
By pressing this button once, the corresponding symbol and the message «DAILY» ap-
pear on the display and you will be able to reduce the cycle duration . The display will
show the reduced washing time. To be used for lightly soiled laundry.
By pressing this button twice, the corresponding symbol and the message «SUPER
QUICK» will appear on the display and you will be able to reduce the cycle duration. The
display will show the reduced washing time.
To be used only for very lightly soiled laundry.
Select the START/PAUSE (button 7)
Press this button, to start the selected programme. The corresponding red pilot light
stops blinking.
On the display will appear the name and the running phase of the selected programme
to indicate that the appliance starts operating and the door is locked.
To interrupt a programme which is running, press the button 7 : the corresponding red
pilot light starts to flash, while the message «PAUSED» appears on the display to indi-
cate that the machine is in pause.
To restart the programme from the point at which it was interrupted, press the button 7
again.
If you have chosen a delayed start, the machine will begin the countdown.
Select the DELAY START (button 8)
This option makes it possible to delay the starting of the washing programme by 30, 60,
90 minutes, 2 hours and then by 1 hour till 20 hours.
Selecting the delay time:
• Select the programme and the required options,
•
Select the desired delay time by pressing the button 8 , the display shows the delay
value and the relevant symbol 9.8 .
The estimated end of the programme time is displayed in 9.7 .
•
Press the button 7 : the machine starts its countdown displayed in 9.8 . The pro-
gramme will start after the selected delay has expired.
You can cancel the delay time at any moment, before you press the button 7 .
Cancelling the delayed start:
•
set the appliance to PAUSE by pressing the button 7 ,
•
press the button 8 until the symbol
disappears on the display,
•
press the button 7 again to start the programme.
The DELAY START option can not be selected with DRAIN or SPIN programmes.
Altering an option or a running programme
It is possible to change some options before the programme carries them out. Before you
make any change, you must pause the appliance the button 7 .
Changing a running programme is possible only by resetting it . Turn the programme
selector dial to
and then to the new programme position. Press the button 5 to can-
16
Daily use