User manual

4. Connect the hose to a tap with a

3/4” thread.

Always use the hose supplied with

the appliance.

Installation should comply with local

water authority and building regula-

tions’ requirements.

A minimum water pressure of 0.05

MPa (0.5 bar) is required for safe op-

eration of the appliance.

If you cannot make the cold water

connection direct from the rising mains, you may be able to operate

the appliance from your cold water storage system.

There should be a minimum distance of 5.02m (16.5 ft) between the

appliance’s inlet and the bottom of the water storage tank.

Aqua Control

The inlet hose is provided with a wa-

ter stop device, which protects

against damage caused by water

leaks in the hose which could devel-

op due to natural ageing of the

hose. This fault is shown by a red

sector in the window „A”. Should this

occur, turn the water tap off and re-

fer to your Service Centre to replace

the hose.