User manual

If the display is not showing any language screen, the appliance has already been switch-

ed on once. In such case, if you would change the language setting, press at the same

time the buttons 2 and 3 for 6 seconds to activate the menu language.

By pressing the button 4 you can scroll all the available languages.

The display says to press the button 5 to confirm the language and then the button 4 to

change the selection.

Press the button 5 twice to confirm your choice.

Setting the time

After the desired language you must set the time before the first wash. Remember to

change the setting time in accordance with daylight-savings time or solar time.

The CLOCK setting permits you to modify/set up the current time. It is important to keep

it updated as the current END Cycle Time depends on it.

To set the time press repeatedly the button 4 to select the settings menu ( SETTINGS )

and confirm your choice by pressing button 5 .

With a single and short pressing of the button 4 , the hours can be adjusted.

Press the button 5 to confirm it. Repeat the previous operation for setting the minutes.

If the appliance has already been switched on once, refer to the beginning of «Personali-

zation» chapter.

PERSONALIZATION

This appliance is provided with a SETTINGS menu that allows you to modify the factory

settings as you want.

When you switch on the machine, by turning the programme selector dial, press the but-

ton 4 to activate the OPTIONS menu. By pressing again the same button you can move

through all the available options till when you locate the SETTINGS menu. Press the but-

ton 5 to access in the menu. Use the button 4 again to scroll all the settings and press

button 5 to confirm your choice.

Setting the brightness

The BRIGHTNESS setting allows you to modify the backlight intensity of the display.

By pressing the button 4 , you can increase or decrease the brightness.

You can choose between different levels from 0 to 9 (0 = min. - 9 = max.).

Press button 5 to confirm your choice.

Setting the contrast

The CONTRAST setting allows you to modify the optical characteristic of the display.

By pressing the button 4 you can increase or decrease the contrast.

You can choose between different levels from 0 to 9 (0 = min. - 9 = max.).

Press button 5 to confirm your choice.

Setting the acoustic signal

The machine is provided with an acoustic device, which sounds in the following cases:

• at the end of the programme

• in the event of operating problems

Personalization