User manual

Aqua Control

The inlet hose is provided with a wa-

ter stop device, which protects

against damage caused by water

leaks in the hose which could devel-

op due to natural ageing of the

hose. This fault is shown by a red

sector in the window „A”. Should this

occur, turn the water tap off and re-

fer to your Service Centre to replace

the hose.

Water Drainage

The appliance drain hose should hook into a standpipe, the hook in the

drain hose is formed using the plastic “U-Piece“ supplied. The standpipe

should have an internal diameter of approximately 38 mm (see dia-

gram) thus ensuring there is an air break between the drain hose and

standpipe.

Important! It is essential to lay the drainage hose without kinks.

When discharging into a stand-

pipe ensure that the top of the

curve in the hose end is no more

than 90 cm (35.4’’) and no less

than 60 cm (23.6’’) above floor

level.