User manual

18
Door and rubber collar
Regularly check whether deposits or foreign bodies are present in the
folds of the rubber collar or on the inside of the glass door.
Clean the glass in the door and the rubber collar regularly.
What to do if...
Remedying small faults yourself
If during use of the appliance one of the following error codes is shown
in the multi-display:
– E10 (Problems with the water inflow),
– E20 (Problems with the water outflow),
– E40 (door open),
please consult the following table.
After the error has been remedied, press the START/PAUSE button.
In the event of other errors (E and a number or letter): Switch the ap-
pliance off and then on again. Set the programme again. Press the
START/PAUSE button.
If the error appears again, please contact your local Service Force Cen-
tre, stating the error code.
Problem Possible cause Remedy
Washing machine does
not work.
Mains plug not plugged in
or fuse not working.
Plug in mains plug. Check
fuse.
Door not closed properly.
Close door - there should be
an audible click.
START/PAUSE button was
not pressed for long
enough.
Press START/PAUSE button
for longer.
Door cannot be closed. Child safety device engaged. Release child safety device.
When a button is
pressed, Err appears in
the multi-display.
The selected function can-
not be combined with the
programme set.
Make another selection.
E40 appears.
END indicator flashes
4x, at the same time an
acoustic signal sounds
4x.
Door is not closed properly.
Close door properly. Start
programme again.