User manual

19
Use
Opening the door after the programme has started
First set the machine to pause by pressing the button 8. After a few minutes the
symbol 7.5 disappears and the door can be opened.
If symbol 7.5 remains lit and the door is locked, this means that the machine is
already heating or that the water level is too high. In this case the door can not
be opened.
If you cannot open the door but you need to open it you have to switch the
machine off by turning the selector dial to
O
. After a few minutes the door can
be opened (pay attention to the water level and temperature!).
After closing the door, it is necessary to select the programme and options again
and to press button
8.
At the end of the programme
The machine stops automatically, the pilot light of button 8 goes off and a
blinking «
0» appears on the display. Some acoustic signal sound for a few
minutes.
T
he symbol
7.5 desappears from the display.
If a programme or an option that ends with water still in the tub has been
selected, the symbol
7.5 remains on, a blinking «0» appears on the display, the
pilot light of button
8 goes off and the door remains locked to indicate that the
water must be emptied out before opening the door.
Follow the below instructions to empty out the water:
● turn the programme selector dial to
O
● select the draining or spinning programme
● reduce the spin speed if needed, by pressing the relevant button
● press button 8
● when the programme has finished the display shows a blinking 0. The symbol
7.5 disappears from the display and the door can be opened.
Turn the programme selector dial to
O
to switch the machine off. Remove the
laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the
door open to prevent the formation of mildew and unpleasant smells.
132960820.qxd 06/10/2008 15.34 Pagina 19