User manual

Problem Possible cause Possible solution
The water inlet hoses
are damaged.
Make sure that the water inlet
hoses have no damages.
The filters in the water
inlet hoses are blocked .
Clean the filters. Refer to 'Care
and cleaning'.
The water taps are
blocked or are furred
with limescale.
Clean the water taps.
The connection of the
water inlet hoses is not
correct.
Make sure that the connection
is correct.
The water pressure is
too low.
Contact your local water author-
ity.
The appliance
does not drain the
water.
The water drain hose is
damaged.
Make sure that the water drain
hose has no damages.
The filter of the drain
pump is blocked.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
The connection of the
water drain hose is not
correct.
Make sure that the connection
is correct.
A washing programme
without the drain phase
is set.
Set the drain programme.
The function Rinse &
Hold is on.
Set the drain programme.
The appliance
door is open or
not closed cor-
rectly.
Close the door correctly.
The anti-flood de-
vice is on.
• Disconnect the appliance.
• Close the water taps.
• Contact the service centre.
The spin phase
does not operate.
The spin phase is off. Set the spin programme.
The filter of the drain
pump is blocked.
Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
Balance problems with
the laundry load.
Adjust manually the items in the
tub and start the spin phase
again.
The programme
does not start.
The mains plug is not
connected in the mains
socket.
Put in the mains plug.
24
www.aeg.com