User manual

Water-stop device

The inlet hose is provided with a water stop de-

vice, which protects against damage caused by

water leaks in the hose which could develop due

to natural ageing of the hose. This fault is shown

by a red sector in the window «A». Should this oc-

cur, turn the water tap off and refer to your Serv-

ice Centre to replace the hose.

Water drainage

The end of the drain hose can be positioned in three ways:

1. Hooked over the edge of a sink using the plastic hose guide supplied with the ma-

chine.

In this case, make sure the end cannot come unhooked when the machine is emptying.

This could be done by tying it to the tap

with a piece of string or attaching it to

the wall.

2. In a sink drain pipe branch. This branch

must be above the trap so that the bend

is at least 60 cm above the ground.

3. Directly into a drain pipe at a height

of not less than 60 cm and not more

than 90 cm.

The end of the drain hose must always be

ventilated, i.e. the inside diameter of the

drain pipe must be larger than the outside

diameter of the drain hose.

The drain hose must not be kinked.

36 Installation