User manual

3. Set the hose correctly by loosening the ring nut. After positioning the inlet
hose, be sure to tighten the ring nut again to prevent leaks.
4. Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
Installation should comply with local water authority
and building regulations requirements. Check the
minimum water pressure required for safe operation of
the appliance in the chapter “Technical Data”.
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system. There should be a minimum verti-
cal distance of 16.5 feet between the appliance’s inlet and the bottom of the water
storage tank.
Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks
in the hose which could develop due to natural ageing
of the hose. This fault is shown by a red sector in the
window “A”. Should this occur, turn the water tap off
and refer to your Service Centre to replace the hose.
Water drainage
The end of the drain hose can be positioned in three ways:
Hooked over the edge of a sink using the plastic hose guide supplied
with the machine.
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with a piece
of string or attaching it to the wall.
In a sink drain pipe branch. This branch must be
above the trap so that the bend is at least 60 cm above
the ground.
Directly into a drain pipe at a height of not less
than 60 cm and not more than 90 cm.
The end of the drain hose must always be ventilated, i.e. the inside diameter of
the drain pipe must be larger than the outside diameter of the drain hose.
The drain hose must not be kinked.
40
Installation
A
352
132961430.qxd 08/08/2008 15.05 Pagina 40