User manual

CAUTION!
Do not put cardboard, wood or
equivalent materials below the
appliance feet to adjust the level.
Make sure that there is sufficient
access after the installation for
possible repairs by a qualified
person.
Installation on suspended
flooring
Suspended wooden floors are particularly
susceptible to vibration. To help prevent
vibration we recommend you place a wa-
terproof wood panel, at least 15 mm thick
under the appliance, secured to at least 2
floor beams with screws, the wood panel
must extend beyond the front feet.
If possible install the appliance in one of
the corners of the room, where the floor is
more stable
THE INLET HOSE
Connect this appliance to a cold
water supply.
• Connect the end of the inlet hose to a
tap with a 3/4" thread. Always use the
hose supplied with the appliance.
20
O
20
O
20
O
45
O
45
O
45
O
Turn the inlet hose only left or right.
Loose the ring nut to set it in the correct
position.
CAUTION!
Make sure that there are no leaks
from the couplings.
Do not use an extension hose if
the inlet hose is too short. Contact
the service centre for the replace-
ment of the inlet hose.
Water pressure
The appliance works correctly if the water
pressure is not less than 0.05 MPa (0.5
bar).
If you can not connect the water inlet
hose to the cold water tap of the primary
hydraulic system, connect it to your do-
mestic cold water storage system.
Make sure not to have more than a dis-
tance of 5.02 m (16.5 ft) between the ap-
pliance inlet hose and the bottom of the
water storage tank.
WATER DRAINAGE
There are different procedures to connect
the drain hose:
32