User manual

Setting the delay timer

3 Using the button (DELAY TIMER) you can delay the start of a pro-

gramme by 30 minutes (30') to a maximum of 23 hours (23h).

1. Select the programme.

2. Press the button (DELAY TIMER) repeatedly until the multi-display

shows the desired time delay, e. g., 12h, if the programme is to start in

12 hours. The indicator (DELAY TIMER) will light up.

3 If the display is showing 23h and you press the button again, the time

delay will be cancelled. 0' will appear followed by the length of the

wash programme that has been set.

3. To activate the delay timer, press the

button (START/PAUSE). The

time remaining to the start of the programme is continuously displayed

(e. g., 12h, 11h, 10h,... 30

' etc.).

Starting a programme

1. Check that the tap is turned on.

2. Press the

button (START/PAUSE). The programme is started or it

starts after the time delay set has elapsed.

3 If after pressing the button (START/PAUSE) E40 flashes in the

multi-display, the (END) indicator flashes 4x and at the same time an

acoustic signal sounds 4x, the door has not been correctly shut. Push

the door firmly closed and press the

button (START/PAUSE) again.

Programme progress

• The programme progress display shows the programme step that is

currently being carried out.

– (Prewash)

– (Main wash)

– (Rinse)

– (Extra Rinse)

– (Spin)

– (End)

• The multi-display shows the estimated time remaining (in hours and

minutes) until the end of the programme.

3 The remaining programme time may increase or briefly remain constant

during the wash programme as the programme adjusts to various con-

ditions while washing (e. g. type of washing, amount of washing, rec-

ognising out-of-balance when spinning, special rinse cycle, etc.).