User manual

4. open the pump door;
5. place a bowl on the floor and place the end of the emergency emptying hose into the
bowl. Remove its cap. The water should drain by gravity into the bowl. When the bowl
is full, put the cap back on the hose. Empty the bowl. Repeat the procedure until water
stops flowing out;
6. clean the pump if necessary as previously described;
7. replace the emergency emptying hose in its seat after having plugged it;
8. screw the pump again and close the door.
Frost precautions
If the machine is installed in a place where the temperature could drop below 0°C, proceed
as follows:
1. close the water tap and unscrew the water inlet hose from the tap;
2. place the end of the emergency emptying hose and that of the inlet hose in a bowl
placed on the floor and let water drain out;
3. screw the water inlet hose back on and reposition the emergency emptying hose after
having put the cap on again.
By doing this, any water remaining in the machine is removed, avoiding ice forming and
consequently damage to the appliance.
When you use the machine again, make sure that the ambient temperature is above 0°C.
Every time you drain the water through the emergency emptying hose you must pour 2
litres of water into the main wash compartment of the detergent drawer and then run the
drain programme. This will activate the ECO Valve device avoiding that part of the deter-
gent remains unused at next washing.
WHAT TO DO IF…
Certain problems are due to lack of simple maintenance or oversights, which can be solved
easily without calling out an engineer. Before contacting your local Service Centre, please
carry out the checks listed below.
During machine operation it is possible that the pilot light of button 5 blinks to indicate
that the machine is not working.
It is possible to recognize the machine fault by the number of button 5 light flashes. If the
number of flashes is different from the ones indicated below, this is related to a fault that
you cannot solve. In this case, contact your local Service Centre.
Press simultaneously the buttons 4 and 5 for a few seconds. The yellow button 5 light will
flash for a short time as described (the green flash is not to be considered) :
• 4 flashes = «The washing machine does not start», follow the corresponding sugges-
tions in «Possible cause/Solutions» box and restart the programme.
• 1 flash = «The machine does not fill», follow the corresponding suggestions in «Possible
cause/Solutions» box and restart the programme.
• 2 flashes = «The machine does not empty and/or does not spin», follow the corre-
sponding suggestions in «Possible cause/Solutions» box and restart the programme.
22 What to do if…