User manual

5. Open the porthole, take out the inlet
hose from the drum and remove the
polystyrene block fitted on the door seal.
6. Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
7. Connect the water inlet hose as descri-
bed under the paragraph «Water inlet».
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the ma-
chine is not impeded by carpets, rugs etc.
Before placing it on small tiles, apply a rubber
coating.
Never try to correct any unevenness in the floor
by putting pieces of wood, cardboard or similar
materials under the machine.
If it is impossible to avoid positioning the ma-
chine next to a gas cooker or coalburning stove,
an insulating panel covered with aluminium foil
on the side facing the cooker or stove, must be
inserted between the two appliances.
The machine must not be installed in rooms where the temperature can drop below 0°C.
The water inlet hose and the drain hose must not be kinked.
Installation
35