User manual

At this point, begins an anti-crease phase which lasts for about 10 minutes.
During this time the door is locked.
Note!
If you whish to open the door before or during the anti-crease phase or to inter-
rupt it, press any button or turn the programme selector dial to any programme
position (except «
O»), the door can be immediately opened.
Turn the selector dial to the «
O» position to switch the machine off.
Remove the laundry.
Automatic washing and drying (NON-STOP programme)
For NON-STOP programmes, it is also essential not to exceed the maximum load
sizes of 3 kg for cotton and 2 kg for synthetics.
Do not use a dosing device/ball when carrying out a washing & drying
programme.
Select the washing and the drying programme by turning the
programme selector dial (1) and buttons 3 and 4
Switch the machine on by turning the selector dial to the selected washing
programme/temperature and press the buttons corresponding to the required
options.
When selecting an «autodrying programme» the pilot lights
10.1 and 10.2
illuminate.
If you press button
3, the display shows the entire duration of the washing and
the selected drying cycle.
If you press button
4 the DRYING TIME value appears on the display for a few
seconds, then the entire duration of the washing and drying cycle appears again.
If possible, do not select a spin speed lower than that proposed by the appliance
to avoid a too long drying time so saving energy.
In any case the reduction of the spin speed is only possible after
selecting drying.
The lowest values you can select are the following:
- with automatic drying: 900 r.p.m. for cottons and synthetics
- with timed drying: 900 r.p.m. for cottons and 800 r.p.m. for synthetics
Select the drying time or dryness degree suitable to your laundry and start the
programme by pressing button
8.
At the end of the programme, follow the instructions given in the corre-
sponding previous chapter.
21
Use
132962771_EN.qxd 22/08/2008 9.15 Page 21