User manual

1. Into a drainage standpipe
Firstly form a hook in the end of the
drain hose using the “U” piece” supplied.
Place the drain hose into your stand-
pipe, which should have an internal di-
ameter of approximately 38 mm thus
ensuring there is an air break between
the drain hose and standpipe.
When discharging into a standpipe en-
sure that the top of the standpipe is no
more than 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre. The joining piece must have an internal diameter
of 18 mm.
If your drain hose looks like this (see be-
low) you do not require the “U” piece”.
Just push the hose firmly in to the
standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used
before, remove any blanking plug that
may be in place.
38 mm (11.2”)
standpipe
diameter
30 cm(12”)
40 Installation