Operation Manual

If the burner does not light after
some tries, check if the crown
and its cap are in correct posi-
tions.
Each control knob has a pilot
light. It lights up when you turn
the control knob.
A
B
C
A)
Burner cap and crown
B)
Thermocouple
C)
Ignition candle
C
D
B
A
A)
Burner cap
B)
Burner crown
C)
Ignition candle
D)
Thermocouple
WARNING!
Do not keep the control knob
pushed for more than 15 sec-
onds.
If the burner does not light after
15 seconds, release the control
knob, turn it into off position and
try to light the burner again after
minimum 1 minute.
In the absence of electricity you
can ignite the burner without
electrical device; in this case ap-
proach the burner with a flame,
push the relevant knob down
and turn it counter-clockwise to
maximum gas release position.
If the burner accidentally goes
out, turn the control knob to the
off position and try to light the
burner again after minimum 1 mi-
nute.
The spark generator can start au-
tomatically when you switch on
the mains, after installation or a
power cut. It is normal.
4.2 Turning the burner off
To put the flame out, turn the knob to
the symbol
.
WARNING!
Always turn the flame down or
switch it off before you remove
the pans from the burner.
8
www.aeg.com