User manual

2. Hold the door trim (B) on the top edge

of the door at the two sides and push

inwards to release the clip seal.

3. Pull the door trim to the front to re-

move it.

4. Hold the door glass panels on their top

edge one by one and pull them up out

of the guide

5. Clean the door glass panels.

To install panels follow the procedure in re-

verse. Install the smaller panel first, then the

larger.

WHAT TO DO IF…

WARNING!

Refer to "Safety information" chapter.

Problem Possible cause Solution

The oven does not heat up The appliance is deactivated Activate the appliance

The oven does not heat up The time of day is not set Set the clock. Refer to "First

setting the time of day"

The oven does not heat up The necessary settings are not

set

Make sure, the settings are cor-

rect

The oven does not heat up The automatic switch-off is ac-

tivated

Refer to „Automatic switch-

off“

The oven does not heat up The fuse is released Make sure, if the fuse is the

cause for the malfunction. If

the fuse releases again and

again, refer to an authorized

electrician

The oven lamp does not oper-

ate

The oven lamp is defective Replace the oven lamp.

The display shows C1 You want to start the pyrolytic

cleaning but you did not re-

move the shelf support (or

telescopic runners).

Remove the shelf support (or

telescopic runners) from the

oven.

26 What to do if…