User's Manual

Page 28
JP1 JP2 JP3 JP4 JP5 JP6 JP7
5. Jumper Settings
Jumper settings are applied to functions such as Start command, transmitter push button layout,
system information (serial number/ID code) programming, and system testing. The jumpers #3 ~ #7
are located on the decoder module above the six (6) dip-switches (refer to Fig.16 below).
(Fig. 16)
▇ Manufacture preset
Jumper Settings Function
JP3
(Blank)
After transmitter inactivity (MAIN deactivated), press
any push button on the transmitter to reactivate the receiver MAIN.
JP3
(Inserted)
After transmitter inactivity (MAIN deactivated), rotate
the transmitter power key-switch to “START” position to reactivate the
receiver MAIN.
JP4
(Blank)
JP5
(Blank)
Standard right-to-left push button configuration for all models.
JP4
(Inserted)
JP5
(Blank)
In-line push button configuration (top to bottom) for FLEX 8ES/EX.
JP4
(Blank)
JP5
(Inserted)
In-line push button configuration (top to bottom) for FLEX 12ES/EX.
JP4
(Inserted)
JP5
(Inserted)
In-line push button configuration (top to bottom) for FLEX 4ES/EX.
JP6
(Blank)
Program system serial number/ID code and channel from decoder module
to I-CHIP.
JP6
(Inserted)
Program system serial number/ID code and channel from I-CHIP
to decoder module.
JP7
(Inserted)
For system test only, receiver MAIN disabled.