Installation guide

If required, use the following procedures to program a new set of Smart Key

and/or Bypass Transponder Cards. Both set of Smart Keys or the Bypass

Transponder Cards must be present and accessible during programming.

Enter Programming Mode

Disarm the system by a valid Smart Key or Bypass Transponder Card. Turn the

Ignition Key to the ACC position. After few seconds switch the Ignition Key to

OFF position and immediately back to ACC position for five times or as following:

OFF ACC OFF ACC OFF ACC OFF ACC OFF ACC. Keep the Ignition

Key in ACC position at the fifth time and the horn will sound twice. (Turn the

Ignition Key to OFF position at any time will exit the programming mode with horn

sound three times)

Smart Key(s) Programming

1. After enter the Smart Key programming mode, LED indicator turns RED. You have

30 seconds window to program. If you do not wish to program Smart Keys, press

the brake pedal once to skip to Bypass Transponder Cards programming (Horn

will sound once to confirm)

2. Press and hold the LOCK button on the first Smart Key until horn sound once.

3. Press and hold the LOCK button on the second Smart Key until horn sound once.

4. Smart Keys programming is now completed. System will automatically enter

Bypass Transponder Cards programming mode.

Bypass Transponder Cards Programming

1. After enter the Bypass Transponder Card programming mode, LED indicator

turns BLUE. You have 12 seconds window to program. To skip Bypass

Transponder Cards programming, press the brake pedal once will end the

programming mode with horn sound five(5) times.

2. Hold first Bypass Transponder Card against the reading field of the Backup

Antenna until the horn sound once.

3. Repeat for the second Bypass Transponder Card until the horn sound five(5)

times to indicate key programming has been successfully completed.

Note: Only one Bypass Transponder Card should be sensed in the reading field

at a time. The sensing range for the Bypass Antenna is under an inch.

Horn Sound Summary Table

Number of Horn Sound

Mode Description

1 x

Remote/ Key Registered

2 x

Entered Programming mode

3 x

Programming failed

5 x

Programming successful

KEY PROGRAMMING PROCEDURE