Installation guide

4
© Copyright Advanced Keys Inc. 2011. All Rights Reserved.
---MAIN HARNESS WIRING DESCRIPTIONS
Main Harness 8-Pin 14-16 Gauge
-
Purple
OUTPUT
500mA
Negative START
-) triggered Starter input. This output
is rated for 500mA. -) side directly.
White
OUTPUT
30A
Positive START
IMPORTANT:Ensure that the ignition current is not rated more than 30A. Connect to external relay with
higher current rating if required.
Red
INPUT
30A
Battery +12V
Connect to a constant +12V supply wire at the ignition switch. Ensure that the OEM input power wire is
fused for more than 30A.
Note:
box or connect directly to the B+ terminal on the battery.
Blue
OUTPUT
30A
ON 2 / 2nd Ignition Output
This output will be +12V in ON and RUN state and OFF during Start (crank) State.
Green
OUTPUT
30A
ON 1 / Primary Ignition Output
Black
INPUT
Ground
Connected to bare, unpainted metal on chassis. It is recommended to use a factory ground bolt rather
than a self-tapping screw. Screws tend to get loose or rusted over time and lead to erratic electrical
problems.
Red
INPUT
30A
Battery +12V
Connect to a constant +12V supply wire at the ignition switch. Ensure that the OEM input power wire is
fused for more than 30A.
Note:
box or connect directly to the B+ terminal on the battery.
Yellow
OUTPUT
30A
ACC
OFF during START (crank) state.
+
+
-
+
+
+
+
System State
Status LED
ACC
ON 1
ON 2
START
OFF
All Off
-
-
-
-
Ready
Amber
-
-
-
-
ACC
Green
12v
-
-
-
ON
Green (Flashing)
12v
12v
12v
-
Step On Brake
Amber (Flashing)
No Change to Any Output
START (Crank)
All Off
-
12v
-
12v
RUN (ON)
Backlight Only
12v
12v
12v
-
Ignition Outputs State Table:
Following table shows state of the ignition outputs when system is in ACC, ON, START and RUN mode:
OPTIONAL
CONNECTIONS - HARNESS