User's Manual
Table Of Contents
- Table of Contents
- System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- 1. Navigating the Terminal Menu
- 2. Menu and System Control
- 3. Menu Descriptions
- > System Status
- > Main Menu
- > System Configuration
- > RF Link Configuration
- > RF Link Performance History (Main Screen)
- > RF Link Error History
- > RF Link Max/Min Received Power History
- > RF Link Min/Max Received Signal Quality History
- > Datapath Provisioning
- > 4xE1 Module Configuration/Status/History (Main Screen)
- > E1x Status/Configuration/Loopback
- > E1x Performance History
- > T1 Module Configuration/Status/History (Main Screen)
- > T1x Status/Configuration/Loopback
- > Ethernet Switch Module Configuration/Status/History (Main Screen)
- > Ethernet Switch Configuration
- > Ethernet Switch Status
- > Management/Utilities (Main Screen)
- > Ping Utility
- > Firmware Upgrade Utility
- > RF Link Management Bridge Configuration
- > System Alarms
- Detail Level Procedures
- MIBs
- Troubleshooting Guide
- 1. Overview
- 2. LED Indicators
- PWR LED
- TST LED
- RF DWN LED
- RF LOW LED
- T1 Interface Alarms
- E1 Interface Alarms
- 1. Display the E1(x) Status screen and check the E1(x) Interface Alarm field to identify the active alarm.
- 1. Verify that the E1 cable is connected to the E1 interface on the TRACER 64x0.
- 2. Verify the connections at the opposite end of the E1 cable.
- 3. Verify that the framing mode (framed, multiframed, or unframed) is the same for both the TRACER 64x0 and the E1 equipment.
- 2. Verify the cable connections for the E1 interface are solid.
- 2. Verify the cable connections for the E1 interface are solid.
- LAN LEDs
- 3. RF Errors
- 4. Step-by-Step Troubleshooting
- 5. Installing/Troubleshooting the TRACER Hardware
Section 5 User Interface Guide TRACER 6000 Series Integrated System Manual
72 Copyright © 2005 ADTRAN, Inc. 612806420L1-1D
> 4XE1 MODULE CONFIGURATION/STATUS/HISTORY (MAIN SCREEN)
Figure 13 shows the TRACER 64x0 E1 Module Configuration main screen, which contains access to the
status, configuration, testing, and performance history parameters for the selected E1 module.
Figure 13. E1 Module Configuration/Status/History (Main Screen)
> E1X STATUS/CONFIGURATION/LOOPBACK
Figure 14 shows the E1x Status/Configuration/Loopback menu page, which displays a real-time graphical
representation for the E1x link using data from both the local and remote TRACER 64x0 units. E1x
operational configuration parameters and testing functions are configured from this menu.
Figure 14. E1x Status/Configuration/Loopback
The following menus for the E1X STATUS/CONFIGURATION/LOOPBACK apply to all four
available E1 interfaces (
A through D).