User Manual
Table Of Contents
- Trademarks
- About this Manual
- Federal Communications Commission Radio Frequency Interference Statement
- Warranty and Customer Service
- Customer Service, Product Support Information, and Training
- 4205 System Description
- Microwave Path Engineering Basics
- Engineering Guidelines
- Network Turnup Procedure
- User Interface Guide
- Troubleshooting Guide
TRACER 4205 System Manual Section 5, User Interface Guide
612804205L1-1A © 2002 ADTRAN, Inc. 41
>TRACER SYSTEM STATUS > FREQUENCY PLAN
Displays the frequency plan (A or B) for the TRACER 4205 unit. For an operational TRACER 4205
system, the local and remote units should display opposite frequency plans.
>TRACER SYSTEM STATUS > SITE
Displays the site name configured from the TRACER System Configuration page.
>TRACER SYSTEM STATUS > RX POWER
Displays the approximate receiver levels (for both the local and remote units) using a series of symbols (#).
The more symbols (#) displayed, the stronger the signal. If the link is down and remote end data is
unavailable, DATA NOT AVAILABLE is displayed in place of the symbols (#).
>TRACER SYSTEM STATUS > TX POWER
Displays the approximate transmitter levels (for both the local and remote units) using a series of symbols
(#). The more symbols (#) displayed, the stronger the signal. If the link is down and remote end data is
unavailable,
DATA NOT AVAILABLE is displayed in place of the symbols (#).
Press <0> from any menu in the TRACER 4205 VT100 menu structure to access the
TRACER System Status page.