Specifications

Section 4.4 ADSL ATM UIG Total Access 600 Series System Manual
242 © 2002 ADTRAN, Inc. 61200624L1-1A
The following settings are used for FRF5.
LAN FR MAINT PROTOCOL
Frame Relay maintenance or signaling
protocol between local V.35 port and the
attached DTE port, support ANSI Annex A,
CCITT Q933 Annex D, CISCO LMI or
Static (no signaling).
LAN FR POLL TIMEOUT
T392 (5-30)
T392 for signaling protocol, typical value
15. No meaning if Maint Protocol is Static.
FRN PORT CONFIG
Logical Frame Relay ports over ATM. Up
to 4 ports are supported with each port
supporting up to 4 DLCI mappings. Go to
NUM field. Typing "i" or "I" will insert
another entry, and typing "d" or "D" will
delete one entry.
NAME
To identify your port.
ATM VPI
Specifies the virtual path over which this
logical port is running.
ATM VCI
Specifies the virtual circuit over which this
logical port is running.
DE MAP
Frame Relay to ATM DE mapping; default
value (Frn Only, ATM 0) suggested.
CLPI MAP
ATM to Frame Relay CLPI map; default
value (Frn Only) suggested.
D/C
Set D/C field in the header to 0 or 1.
HEADER
Header format; only 2 bytes supported now.
MAINT PROTOCOL
Maintenance or signaling protocol over this
logical Frame Relay port. Support Annex A,
Annex D, CISCO LMI or Static.
MUX MODE
Many DLCIs or one DLCI mapping over this
port.
DLCI MAP
Actual DLCI mappings.
LAN DLCI
The DLCI configured over local V.35
Frame Relay port.
NET DLCI
The DLCI configured over the WAN
side logical Frame Relay port.
ACTIVE
Always active, not configurable.