Specifications

Total Access 600 Series System Manual Section 4.2 T1 TDM UIG

BRIDGE > CONFIG > INTERFACES (ETH[1])

Configure the Ethernet Bridging parameters from this menu.

BRIDGE > CONFIG > INTERFACES (ETH[1]) > SUB-INTERFACE

The Ethernet sub-interface is 802.3[1.0]. The [1.0] represents the Ethernet physical and logical ports,

where 1 is the physical port and 0 is the logical port assigned to the Ethernet interface. This is a read-only

field.

BRIDGE > CONFIG > BRIDGE TABLE

Configure the bridge table parameters from this menu.

BRIDGE > CONFIG > BRIDGE TABLE > BRIDGE TABLE AGING (0-65535)

BRIDGE TABLE AGING is how soon an entry ages out of the Bridge table (in minutes). Default is 5.

BRIDGE > STATUS

View the bridging statistics from this menu.

BRIDGE > STATUS > BRIDGE TABLE

View the bridge table status from this menu.

BRIDGE > STATUS > BRIDGE TABLE > MAC ADDRESS

Ethernet address for device learned. This is a read only field.

BRIDGE > STATUS > BRIDGE TABLE > LOCATION

Location indicates if it is LAN or WAN. This is a read-only field.

BRIDGE > STATUS > BRIDGE TABLE > TTL

Time to Live (TTL) is the number of seconds until the address is removed from the table. This is a read

only field.

The ETH[1] interface will not appear as a bridge interface entry if the mode is set to route

IP.