Owner's manual

ADS Environmental Services ADS Spider User Manual
Page 89
Change the Spider default IP address and mask to the new values as
follows:
1. Keep on briefly pressing the keypad key until the display
shows:
I192.168.000.187
M255.255.255.000
2. Press the keypad key and hold it down for more than 3
seconds. Release the key. The display will show:
Change IP addr ?
192.168.000.187
3. Press the keypad key and hold it down for more than 3
seconds. Release the key. A flashing cursor will appear over
the first digit on the second line.
4. A brief key press will increment the digit under the cursor,
while a long press (longer than 3 sec) will move the cursor to
the next digit.
5. After the last digit is entered, the display will show the
message in step 2 again.
6. Briefly press the key. The display will show:
Change net mask?
255.255.255.000
7. If you need to change the mask, enter the change mode with
a long press and then change digits in the same manner as
described in Step 4 above.
8. After the last digit is entered, the display will show the
message in step 6 again. Briefly press the key until the
display shows:
Save ?
9. A long press will save the new values for the IP address and
mask and return the display to normal operation.
10. If you change your mind and do not want to change the
values, exit the change mode (indicated by the flashing
cursor) by waiting for 20 seconds and then briefly pressing
the key until the display shows:
Cancel ?
A long press now will cancel all changes and return the
display to normal operation.
11. You must power down and then power up the Spider for the
new values to take effect.