Manual

Addictive Desert Designs

2005 – 2014 Toyota Tacoma

50” Straight bar roof mount

Installation instructions

PREPARATION STEPS

1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the

emergency brake set.

2. You will need the following tools:

a. Drill

b. 1/4” Drill Bit

c. 1/4” Rivets (6)

d. Tape Measure

Note: This installation requires 2 people for best results

3. Included in Kit:

a. Right Mount(1)

b. Left Mount(1)

PAGE 1
Addictive Desert Designs 2005 – 2014 Toyota Tacoma 50” Straight bar roof mount Installation instructions PREPARATION STEPS 1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the emergency brake set. 2. You will need the following tools: a. Drill b. 1/4” Drill Bit c. 1/4” Rivets (6) d. Tape Measure Note: This installation requires 2 people for best results 3. Included in Kit: a. Right Mount(1) b.
PAGE 2
INSTALLATION INSTRUCTIONS 1. Mount light bar into both Roof Mounts to create an assembly. 2. Carefully remove the weatherstrip from the door Jams. 3. Carefully measure mount locations by measuring 16 ¼ " from lower pillar at Fender to bottom of mount at the location shown below. Do this for both sides of the truck.
PAGE 3
4. With the bracket in position, mark and drill the three holes with the 1/4” drill bit and install the rivets and bracket according to the rivet tool manufacturer’s instructions. Repeat for the other side. 5. Replace the molding on both sides and wire the light according to instructions included with the light. 6. Stand back and enjoy your A.D.D. Light Mount.
PAGE 4
For additional support or technical questions, please call 480.671.0820 or email info@addictivedesertdesigns.com Addictive Desert Designs 4840 E. Jasmine Street Suite 112 Mesa, AZ 85205 www.addictivedesertdesigns.