User's Manual
Table Of Contents
- Document Overview
- Overview of RF Modules for Prism Remote Units
- RF Module Components
- Understanding the RF Module Cables
- Install the RF Module(s)
- Safety Precautions
- Guard against Damage from Electro-Static Discharge
- Unpack and Inspect the RF Module
- Remove Release Liners from the RF Module
- Dual-Bay Modules Only—Remove the Module Bay Shelf
- Install the RF Module into the Prism Remote Chassis
- Secure RF Module Latches
- Connect the RF Module Cables
- Power on the RF Module
- Standards Certification
- Accessing User Documentation on the TE Customer Portal
- Contacting TE Connectivity
FlexWavePrismRemoteUnitRFModuleInstallationGuide Page17
TECP‐77‐141Issue6 • 300001744178RevF • April2014 ©2014 TEConnectivityLtd.
TheLegacyDual‐Bay40WRFModuleoccupiestwobaysinaPRU.Figure8showsthemaincomponentsinaPRU
enclosure,withaLegacy40WRFM
oduleoccupyingBaysAandB.ThecontrollingDARTwillalwaysbeinthe
upperbay(BorD),andthesecondLPAisalwaysinthelowerbay(AorC).
Legacy Dual-Bay 40W RF Module
in Bay B (upper slot) and
Bay A (lower slot) with the
controlling DART in Bay B
AC or DC power switch
Four DC power switches
SeRF Module and Power supplies
Bay C (empty for future use)
Bay D (empty for future use)
Fans
Connectivity panel with Status LED
Figure8.LegacyDual‐Bay40WRFModuleinaQuad‐BayPRU
NOTE: IfaLega
cyDual‐Bay40WRFModuleAWS2100andaLegacyDual‐Bay40WRFModulePCS1900areboth
installedinaQuad‐BayPRU,itisrecommendedthatthePCS1900beinstalledinupper‐mostbay,andthe
AWS2100beinstalledinthelower‐mostba
y.
NOTE: To accommodate two‐bay modules, you need to remove a module bay shelf as described in “Dual‐Bay
ModulesOnly—RemovetheModuleBayShelf”onpage21.