User's Manual

Rebooting a Unit
Page 164 FlexWave Prism Element Management System 7.1 User Manual
©
2011 ADC Telecommunications, Inc ADCP-77-177 • Issue 1 • July 2011
REBOOTING A UNIT
CAUTION! The system configuration is stored on the Host. Rebooting the Host therefore results in a
loss of RF for the Host and connected Remote Units until the Host comes back up.
Depending on the system configuration, it can take 5 to 20 minutes before management
communication is restored.
CAUTION! Host configuration persists across a Reboot. However, the current EMS session will close
and you will need to log back in to the EMS after the Host reboot has completed.
CAUTION! Rebooting a Remote Unit causes Loss of Service and should not be used unless other
troubleshooting processes have been followed and did not fix the issue being experienced
at the PRU/URU.
1 In the System Tree, click on the icon of the unit that you want to reboot.
2 In the Unit Menu bar, click Unit Configuration > Reboot, to open the Unit Configuration
> Reboot page.
3 Click Reboot.
• Once the reboot starts, a process message displays.
• After the reboot has completed, a Unit has been rebooted message displays.
• After the Host reboots, the EMS login window opens.