User's Manual

Table Of Contents

ADCP-75-347 • Issue 1 • 04/2008 • Preface

Page vi

STANDARDS CERTIFICATION

FCC: This equipment complies with the applicable sections of Title 47 CFR Part 15 (Host

unit), Part 22 (800 MHz Cellular), Part 24 (1900 MHz - PCS), and Part 90 (800/900 - SMR).

IC:

This equipment complies with the applicable sections of RSS-131. The term “IC:” before the

radio certification number only signifies that Industry Canada Technical Specifications were met.

The Manufacturer's rated output power of this equipment is for single carrier operation. For

situations when multiple carrier signals are present, the rating would have to be reduced by 3.5

dB, especially where the output signal is re-radiated and can cause interference to adjacent band

users. This power reduction is to be by means of input power or gain reduction and not by an

attenuator at the output of the device.

Note: To comply with Maximum Permissible Exposure (MPE) requirements, the maximum

composite output form the antenna cannot exceed 1000 Watts ERP (Cellular and SMR), the

antenna cannot exceed 1640 Watts EIRP (PCS), and the antenna must be permanently installed

in a fixed location that provides at least 6 meters (20 feet) of separation from all persons.

UL/CUL:

This will be installed in a restricted access location. This equipment complies with

NEMA Type 6, per UL and CUL 50, Standard for Enclosures for Electrical Equipment. This

equipment provides the degree of protection specified by IP67 as defined in IEC Publication 529.

FDA/CDRH: This equipment uses a Class 1 LASER according to FDA/CDRH Rules. This

product conforms to all applicable standards of 21 CFR Part 1040.

Caution: Modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

Danger: This equipment uses a Class 1 Laser according to FDA/CDRH rules. Laser radiation

can seriously damage the retina of the eye. Do not look into the ends of any optical fiber. Do not

look directly into the optical transceiver of any digital unit or exposure to laser radiation may

result. An optical power meter should be used to verify active fibers. A protective cap or hood

MUST be immediately placed over any radiating transceiver or optical fiber connector to avoid

the potential of dangerous amounts of radiation exposure. This practice also prevents dirt

particles from entering the adapter or connector.

Caution: This system is a RF Transmitter and continuously emits RF energy. Maintain 3 foot

(91.4 cm) minimum clearance from the antenna while the system is operating. Wherever

possible, shut down the RAN before servicing the antenna.

Caution: Always allow sufficient fiber length to permit routing of patch cords and pigtails

without severe bends. Fiber optic patch cords or pigtails may be permanently damaged if bent

or curved to a radius of less than 2 inches (5.1 cm).

Caution: Exterior surfaces of the RU may be hot. Use caution during servicing.

Caution:

Cooling fins on the Remote Unit may have sharp corners and edges, to prevent cuts and

scrapes always wear gloves and appropriate protective clothing when handling the Remote Unit.