User Manual
Table Of Contents
- FlexWave microBTS 1 x 1 and 2 x 1 Installation and Commissioning Guide
- Chapter 1 - Introduction
- Chapter 2 - Unpacking and Inspection
- Chapter 3 - Mounting Procedures
- Chapter 4 - Installation Procedures
- 4.1 Installation Overview
- 4.1.1 Installation Hardware Provided with microBTS Enclosure
- 4.1.2 Tools and Materials Required
- 4.1.3 Ground Wire Installation
- 4.1.4 Network Listen Antenna Installation
- 4.1.5 IP Backhaul Cable Installation
- 4.1.6 Base Station Antenna Cable Installation
- 4.1.7 AC Power Wiring Installation
- 4.1.8 DC Power Wiring Installation
- 4.1.9 Touch-Up Painting
- 4.1.10 Shield Installation (option)
- 4.2 microBTS Replacement
- 4.1 Installation Overview
- Chapter 5 - microBTS Initial Configuration
Page 16 FlexWave microBTS Installation and Commissioning Guide
© 2009, ADC Telecommunications, Inc.
ADCP-77-086 • Issue 2 • 04/2009 • Chapter 3 - Mounting Procedures
3.1.5 Tools and Additional Materials Required For Mounting
The tools and any additional materials required for mounting the microBTS are dependent on
the mounting system. The following sections list the tools required for the various mounting
systems and are not supplied by ADC.
Wood-Framed Wall Mounting
• 9/16 inch wrench
• 1/2 inch wrench (2)
• Torque wrench with 3/16-inch hex key socket
• Drill
• Pencil or marker
• 4 foot (122 cm) x 2 foot (61 cm) sheet of pressure-treated 3/4 inch (19 mm) plywood
• Fasteners and tools for securing the 3/4 inch (19 mm) plywood to wall
• 3/16 inch standard drill bit
Masonry Wall Mounting
• 9/16 inch wrench
• 1/2 inch wrench (2)
• Torque wrench with 3/16 inch hex key socket
• Drill
• Pencil or marker
• 5/8 inch masonry drill bit
Wooden Utility Pole Mounting
• 9/16 inch wrench
• 1/2 inch wrench (2)
• Torque wrench with 3/16 inch hex key socket
• Drill
• Pencil or marker
• 3/16 inch standard drill bit
Metal Utility Pole Mounting
• Clamp banding tool (BT1HT from Panduit)
• 1/2 inch wrench (2)