Installation Guide

Remove the Weather-Resistant Cover

Access the battery compartment by pulling off the weather-resistant cover.

Be careful not to damage the cover during removal.

Set the Time

Turn the set knob on the back of the clock in either direction.

Install or Replace Batteries

AcuRite recommends high quality alkaline or lithium batteries for the

best product performance. Heavy duty or rechargeable batteries are not

recommended.

The clock requires lithium batteries in low temperature conditions. Cold

temperatures can cause alkaline batteries to function improperly. Use

lithium batteries in the clock for temperatures below -4ºF / -20ºC.

Insert 1 x AA alkaline or lithium battery into the battery compartment,

as shown. Follow the polarity (+/-) diagram in the battery compartment.

Replace the weather-resistant cover and secure using screws.

Calibrate the Temperature and Humidity

The pointer may move during shipping, causing the thermometer/

hygrometer to read temperature/humidity inaccurately. If the

thermometer/hygrometer is reading incorrectly, compare the temperature/

humidity reading to a known accurate thermometer/hygrometer. Let

both thermometers/hygrometers adjust to room temperature for at least

three hours. If the new thermometer/hygrometer continues to read

inaccurately, adjust the pointer by turning knob on the back of the unit in

the appropriate direction.

DO NOT HANG IN DIRECT SUNLIGHT!

For the most accurate temperature readings choose a location that will not be

exposed to direct sunlight or other direct heat sources.

Instruction Manual

Outdoor Clock

with Temperature and Humidity

PAGE 1
Instruction Manual Outdoor Clock with Temperature and Humidity 1 Remove the Weather-Resistant Cover Access the battery compartment by pulling off the weather-resistant cover. Be careful not to damage the cover during removal. 2 Set the Time Turn the set knob on the back of the clock in either direction. 3 Install or Replace Batteries AcuRite recommends high quality alkaline or lithium batteries for the best product performance. Heavy duty or rechargeable batteries are not recommended.
PAGE 2
1 2 Remove the Weather-Resistant Cover Set the Time 3 Calibrate the Temperature and Humidity 4 4 Install Battery 1 AA battery Calibrate the Temperature and Humidity Care & Maintenance Clock Care • A soft cloth may be used to clean the clock, as needed. • Do not use corrosive cleaners or chemicals on the clock. • Always store the clock without a battery when not in use.