Operation Manual

English

Problems with the Projector

9 Image is too small

or too large

• Adjust the zoom lever on the front of the projector.

• Move the projector closer to or further from the

screen.

• Press "MENU" on the remote control. Go to "Image

--> Aspect Ratio" and try different settings or

press"Aspect Ratio" on the remote control to adjust

directly.

10 Image has slanted

sides

• If possible, reposition the projector so that it is

centered on the screen.

• Press the "Keystone / " button on the remote

control until the sides are vertical.

• Press "MENU" on the remote control. Go to "Image -

-> Auto Keystone" and choose "Off" on the OSD, if

"Keystone" button is not available on the remote

control.

11 Image is reversed

• Select "Image --> Projection" on the OSD and adjust

the projection direction.

# Condition Solution

1 The projector stops responding

to all controls

If possible, turn off the projector, then

unplug the power cord and wait at least 30

seconds before reconnecting power.

2 Lamp burns out or makes a

popping sound

When the lamp reaches the end of its useful

life, it will burn out and may make a loud

popping sound. If this happens, the projector

will not turn on until the lamp module has

been replaced. To replace the lamp, follow

the procedures in the "Replacing the Lamp"

section.