User Manual
9. DDC/CI: Allows the monitor settings to be set through the software on the PC.
---------------------------------------------------------------------------------------------------------
Note:
DDC/CI, short for Display Data Channel/Command Interface, which
allows monitor controls to be sent via software.
10. HDMI Black level setting.
11. Quick start mode: Select O or On. Turn on to speed up boot speed.
12. DP ALT Mode: Default set USB 3.0 function OFF. Turn on USB 3.0 function, Using
higher speed for data transport, display port only occupy on two lanes.
On: Using 2 lanes for USB 3.0 high speed data and 2 lanes for DisplayPort signal.
DP ALT maximum display resolution is QHD (3440x1440-30Hz).
O: Using full lanes to transport DisplayPort signal.
13. Power-o USB charge: Turn On or O.
---------------------------------------------------------------------------------------------------------
Note:
To comply with international power standards, the Power o USB charge
is set to o by default, The sleep mode cannot be resumed under the USB
Type-C input. To wake up from sleep (via PC), the user needs to change the
Power o USB to on.
Save Setting to…(User mode only)
Mode - User
System
Mode: Eco
Picture
Color
Mode: Standard
Audio
OSD
Mode: Graphics
Enter
Move
X
Mode: Movie
Save seng to...
Performance
1. Press the MENU key to open the OSD.
2. Toggle the joystick to the up or down to select "Save Setting to..." from the OSD.Then
toggle to the right to
navigate to the element you wish to adjust and press the joystick
to enter it.
3. Save Setting to some mode: There are four user-dened proles available. When you
have decided what settings suit you, save them and system will be able to recall the
settings in the future when you turn on these mode.