Laptop User Manual
Table Of Contents
- Aspire M5910(G) Service Guide
- Table of Contents
- System Tour
- System Utilities
- System Disassembly
- Disassembly Requirements
- Pre-disassembly Procedure
- Removing the Side Panel
- Removing the Heat Sink Fan Assembly
- Removing the Processor
- Removing the VGA Card
- Removing the TV Card
- Removing the Mode Card
- Removing the Hard Disk Drive
- Removing the Front Bezel
- Removing Rear USB Board
- Removing the Cables
- Remove System FAN
- Removing the Optical Drive
- Removing the Power Supply
- Removing the Memory Modules
- Removing the removable HDD bay
- Removing the Mainboard
- System Troubleshooting
- Jumper and Connector Information
- FRU (Field Replaceable Unit) List
![](/manual/acer/aspire-m5910-g/laptop-user-manual/images/img-37.png)
29 Chapter 3
Removing the Heat Sink Fan Assembly
WARNING:The heat sink becomes very hot when the system is on. NEVER touch the heat sink with any metal
or with your hands.
1. disconnect the fan cable from the mainboard.
2. Use a long-nosed screwdriver to loosen the four screws on the heat sink, in the order as shown below.
3. Lift the heat sink fan assembly away from the mainboard.