Owner's Manual

English

connection to its network. It indicates no endorsement of the product by Telecom,

nor does it provide any sort of warranty. Above all, it provides no assurance that any

item will work correctly in all respects with another item of Telepermitted equipment

of a different make or model, nor does it imply that any product is compatible with all

of Telecom's network services.

2 This equipment is not capable, under all operating conditions, of correct operation at

the higher speeds for which it is designed. Telecom will accept no responsibility

should difficulties arise in such circumstances.

3 Some parameters required for compliance with Telecom's Telepermit requirements

are dependent on the equipment (PC) associated with this device. The associated

equipment shall be set to operate within the following limits for compliance with

Telecom's Specifications:

a There shall be no more than 10 call attempts to the same number within any 30-

minute period for any single manual call initiation, and

b The equipment shall go on-hook for a period of not less than 30 seconds

between the end of one attempt and the beginning of the next call attempt.

4 Some parameters required for compliance with Telecom's Telepermit requirements

are dependent on the equipment (PC) associated with this device. In order to operate

within the limits for compliance with Telecom's specifications, the associated

equipment shall be set to ensure that automatic calls to different numbers are spaced

such that there is not less than 5 seconds between the end of one call attempt and the

beginning of another.

5 This equipment shall not be set up to make automatic calls to Telecom's 111

Emergency Service.

6 This device is equipped with pulse dialing while the Telecom standard is DTMF tone

dialing. There is no guarantee that Telecom lines will always continue to support

pulse dialing.

7 Use of pulse dialing, when this equipment is connected to the same line as other

equipment, may give rise to bell tinkle or noise and may also cause a false answer

condition. Should such problems occur, the user should NOT contact the telecom Fault

Service.

8 This equipment may not provide for the effective hand-over of a call to another

device connected to the same line.

9 Under power failure conditions this appliance may not operate. Please ensure that a

separate telephone, not dependent on local power, is available for emergency use.

LCD pixel statement

The LCD unit is produced with high-precision manufacturing techniques. Nevertheless,

some pixels may occasionally misfire or appear as black or red dots. This has no effect on

the recorded image and does not constitute a malfunction.

Radio device regulatory notice

Note: Below regulatory information is for models with wireless LAN and / or

Bluetooth only.