User Manual

41
To remove a slim-line optical drive:
1 Perform the pre-installation instructions described on page 28.
2 Remove the front bezel. Perform the instructions described in “To
remove the front bezel” section on page 29.
3 Remove the access panel. Perform step 2 described in the “To
install a slim-line optical drive” section on page 38.
4 Disconnect the data and power cables from the rear of the optical
drive.
5 Remove the two screws that secure the optical drive to the chassis.
6 Lift the optical drive from the chassis.
7 Remove the two screws at the rear of the optical drive to detach
the interposer board.
8 Observe the post-installation instructions described on page 28.