Instruction Manual

JBOD System Quick Start Guide
18
Step 4: Making Connections
The JBOD system has two controllers, each controller has three x4 SAS
ports that enables you to connect to a host computer, a RAID system or
expand the JBOD enclosure.
Use a x4 SAS cable to connect the JBOD system to a host computer or to
a RAID system. Follow the procedures below:
1.Insert the SAS cable into the CH1 port of A16R-SJ.
2.To connect to a RAID system, insert the other end of the SAS cable to
the EXP port of the RAID system(B). Or to connect to a host server,
insert the other end of the SAS cable to the HBA connector of the host
server (C).
Note
To configure, see .
A
B
C
HBA card of host server
RAID system connection. A16R-FS
Fibre RAID system is shown above.