Installation Manual

87
20.2.1 Call Mode
Select the corresponding function. For a list of functions and their attributes, see the
table below.
Function Meaning
Deactivated No social care messages are transmitted to the social
care unit.
Single The alarm centre transmits social care messages to the
first phone number in the phone book together with the
first account number for identification. If transmission if
not confirmed, the alarm centre repeats the call up to 15
times.
Alternate The alarm centre first transmits social care messages to
the first phone number in the phone book. If the line is
busy, then the social care message is transmitted to the
second number in the phone book. This continues up to
15 times until confirmed, always alternating between the
two phone numbers.
20.2.2 Primary Telecoms
Select which primary transmission path should be used. This transmission path is used
as long as transmission is possible using it.
20.2.3 Phone Book (Social Care)
Select which number should be changed.
Enter the callback number of the command centre that you received for transmitting
the respective report. Press the star key to enter a dial pause. Each dial pause
interrupts the dial procedure for 3 seconds.
20.2.4 Account Numbers
Select which account number should be changed.
Enter the account number that you have received for transmitting from the command
centre.
Save all account numbers that should be transmitted by the wireless alarm centre
during a social care report.
An account number can be eight characters long when reporting social care
messages.
When the Scancom or Scanfast report types are used (see below), then the wireless
alarm centre uses the last four to six characters of the account number. When four
characters are entered, then the wireless alarm centre only uses these four characters.
When five characters are entered, the wireless centre adds a zero to the front of the
number (number now has six digits).
When the Tunstall report type is used, the wireless centre adds zeroes to the front of
the number to increase shorter account numbers to eight characters.
Installer Menu Æ Reporting Æ Social Care Æ Account Numbers Æ Account No P 1
Account No P 2
Account No P 3
Account No P 4
x“P” (partition) has now been added (previously “Account No 1” etc.).
xAn ID must be entered for the corresponding partition so that social care
messages in this partition are transmitted correctly.