Installation Manual

43
12. Installer menu
The wireless alarm centre is configured in the installer menu.
There are two ways of programming the wireless alarm centre:
A: Over the keypad on the wireless alarm centre.
B: Over the software (either locally or by remote data transmission).
The following section describes how to program the wireless alarm centre using the
keypad. To program the wireless alarm centre using the software, please consult the
software instructions.
The menu is graphically designed to be used almost intuitively. The control buttons are
used to navigate around the menu.
Using the arrow keys, you can navigate up and down within a menu item.
The keys on the left and right side relate to the text displayed above the keys in the
display.
12.1 First steps in the installer menu
In the user mode, proceed as follows:
If you are in user mode, you must first change to the installer mode. Do this as follows:
Enter a valid installer code (default setting = 7890): 7 8 9 0
You may also have to enter an administrator code (default setting = 1234) or user
code. The following announcement is heard:
“You are now in the installer menu”
When exiting the installer menu, the following announcement is played:
“You have exited the installer menu”
12.2 Overview of menu items in the installer menu
In the installer menu, wireless detectors can be trained, controllable outputs can be
configured and partitions can be defined. The following table provides an overview of
the various menu items:
Menu item Settings
Detector Train/delete detector, configure zones
Outputs Add and edit outputs
Other Devices
Set up external sirens, WAM (Wireless Accessory Module),
info module, arming station
Partitions Assign partitions to zones, configure partitions
If the code is entered incorrectly four times in succession, the keypad
(except for the alarm buttons) is then locked for 90 seconds.