Installation Manual

3.5 Accessing the alarm centre

In order to not trigger an alarm when leaving (Ext Time) or entering (Ent Time) the

area, a delay time must be defined for accessing the centre in Partition 01.

Access the installer menu and set the exit or entry delay under the “Partitions” menu

item.

Select Partions 01.

Select the “Name” menu item, then enter a new name for the partition: Ground floor

Select the type: Time

Set 10 seconds for the exit delay time and 120 seconds for the entry delay time.

In our example, the ground floor (Partition 01) is set as follows: Opening detector

OD13-GF-HA Type: Final Exit

Motion sensor MS4-GF-HA Type: Entry Route

When the house is exited, the system is activated within 10 seconds.

When returning to the house, you have 120 seconds to disable the system.

You must deactivate the system within 120 seconds and may not enter

any other areas where the detectors are not set to Entry Route.

In the installer menu:

Select the Partitions menu item.

OD13-GF-HA

MS4-GF-HA

Å Exit = 10 seconds

Entrance = 120 seconds Æ