User's Manual

-
26 -
If selected the AP that listed in the WPS Profile List field, users can click the
Detail button to see more AP information.
SSID: Shows the connected AP network name.
BSSID: The MAC address of the connected AP. Fixed and cannot be
changed.
Authentication Type: The authentication type support Open, WPA-PSK
and WPA2-PSK.
Encryption Type: For Open authentication mode, the selection of
encryption type are NONE and WEP. For WPA-PSK and WPA2-PSK
authentication mode, the encryption type supports both TKIP and AES.
Key Length: Only valid when using Open authentication mode and WEP
encryption. There are key lengths 5, 10, 13 and 26.
Key Index: Only valid when using Open authentication mode and WEP
encryption. There are 1~4 key index.
Key Material: The key material can be used to ensure the security of the
wireless network. Fill in the appropriate value or phrase in Key Material
field.
Show Password: Check this box to show the passwords that have been
entered.
OK: Click to save and apply the new settings.
Cancel: Click to leave and discard the settings.
Connect
Command to connect to the selected network inside credentials. The active
selected credential is as like as the active selected Profile.
Rotate
Command to rotate to connect to the next network inside credentials.
Disconnect
Stop WPS action and disconnect this active link. And then select the last
profile at the Profile Page. If there is an empty profile page, the driver will
select any non-security AP.