User's Manual

12
Status
In this screen, you can see the current settings and status of this Access Point. You can
change settings by selecting specific tab described in below.
System
System
Uptime
The time period since the device was up.
Firmware Version
The current version of the firmware installed in this device.
Wireless Configuration
Mode
There are four modes supported, Access Point, Client (Ad-
hoc and Infrastructure), WDS Bridge and WDS repeater.
The default mode is Access Point. If you want to change to
bridge mode, please go to Wireless/WDS Setting to enable
the WDS function.
Band
Shows the wireless band.
SSID
The SSID differentiates one WLAN from another, therefore,
all access points and all devices attempting to connect to a
specific WLAN must use the same SSID. It is case-sensitive
and must not exceed 32 characters. A device will not be
permitted to join the BSS unless it can provide the unique
SSID. An SSID is also referred to as a network name because
essentially it is a name that identifies a wireless network.
Channel Number
The number of channels supported depends on the region of
this Access Point. All stations communicating with the Access
Point must use the same channel.
Encryption
WEP Encryption (Wired Equivalent Privacy) is set to