Datasheet

ABB I Fastening Solutions – 147
Material specications
Adhesive material specications
Property Method Unit of measure Rubber based
(self-adhesive)
Acrylic based
(2 component glue)
Coated Sides
– each 2 2
Foam Density
– Kg/m3 96.9 96.9
Peel Adhesion
PSTC 1 N/cm width 10.9 10
ASTM D 1000 Average 8.8
Shear Adhesion
natural 15.0 15.0 10
22°C 50% RH
PSTC 7 Hours 100 + 8 +
22°C Occasional Wetting
N/m2 68971 15174
Tensile Strength
ASTM D 412 PSI 100 100 +
Tear Resistance
ASTM D 624 N/cm 52.6 52.6 +
Elongation at Break
– % 400 200
Service Temperature
– °C Min -18 -29
– °C Max +66 +79
Flammability
ASTM D 624 Slow Burn Slow Burn
Installation instructions for self-adhesive mounting bases
- Mounting surfaces should be cleaned with alcohol based (IPA) cleaner before application
- The self-adhesive mounting bases have a double-sided adhesive tape made of synthetic
foam, covered by a protecting foil.
- To install the self-adhesive mounting base, remove the protecting foil and press the moun-
ting base onto the cleaned surface
- The thickness of the self-adhesive foam (0.8 mm) compensates the irregularities of the ap-
plication surfaces and allows installations on structured surfaces of cabinet doors, on sheet
metal, on machines, etc
- The adhesion is achieved immediately during the installation, which means that later reposi-
tioning is not possible
Product Ref.: TC2PA
Characteristics
- 2 component glue
- Consists of one tube each of adhesive and activator
- Easy application
- Stable and durable adhesion
- Applicable on all Polyamide and Aluminium mounting bases and cable clamps
- Also applicable on concrete and other porous surfaces
- UV resistant
Technical Information
Description 2 component glue
Weight 0.21 kg
Installation instructions for Product Ref. :
TC2PA (2 component glue)
- Mounting surfaces should be cleaned before application
- The liquid adhesive in the tube is to be spread onto the mounting surface. It can be used on
most rough surfaces (like concrete)
- The activator liquid is then spread onto the surface of the mounting base
- Place the surface of the mounting base in contact with the surface where it has to be mounted,
position the mounting base correctly and then press rmly
- Repositioning the mounting base remains possible only for a few seconds
- Do not use the mounting base immediately after installation. The Acrylic-based adhesive re-
quires a set-up time that can be inuenced by factors such as temperature (allow 24 - 72 hours
for maximum performance)
- Temperature of installation needs to be above +20°C