700 Series Overhead Projector Operator’s Guide Série 1700 Rétroprojecteur Guide de l’utilisateur Serie 1700 Retroproyector Manual del Operador
Go to Main Menu Go to Operator Guide Table of Contents INTENDED USE Before operating the machine, please read the entire manual thoroughly. The 3Mt Overhead Projector 1700 was designed, built and tested for use indoors, using 3M brand lamps and nominal local voltages. The use of other replacement lamps, outdoor operation or different voltages has not been tested, and could damage the projector or peripheral equipment and/or create a potentially unsafe operating condition.
Go to Main Menu Go to Operator Guide Table of Contents Product Description and Machine Characteristics The 3MtOverhead Projector 1700 Series is designed to be safe, efficient and easy to use.
Go to Main Menu Go to Operator Guide Table of Contents Operating Instructions Read the Important Safeguards before operating this projector. 5. Adjust angle of projection head (2) to raise or lower the image on the screen. 1. Position projector in front of the projection screen. 2. Plug power cord into electric outlet. 3. Push power switch (4) “On” to illuminate lamp. 4. Rotate projector (1) until projected light beam is perpendicular (90_) to the screen surface.
Go to Main Menu Go to Operator Guide Table of Contents Color Tuning Dial Rotate the color tuning dial (if equipped) to eliminate the yellow/orange to brown or blue corners on the screen. 1. Rotate dial to the left to remove blue corners. 2. Rotate dial to the right to remove yellow/orange to brown corners. Lamp Replacement Use the proper lamp type for your projector. ENX – 82V, 360W 78-6969-8027-1 2 To replace the lamp: 1. Turn projector off and unplug (1) the power cord. 2.
Go to Main Menu Go to Operator Guide Table of Contents Troubleshooting Problem Probable Causes A new lamp has been installed and a. Projector not plugged in neither lamp nor fan energize b. No power at wall outlet c. Top cover not completely closed Lamp does not illuminate but fan motor runs After replacing a burned out lamp, the new lamp fails a. Lamp is not seated properly in socket b. Lamp is burned out a. Defective lamp was installed b. Possible electrical problem Short lamp life.
Go to Main Menu Go to Operator Guide Table of Contents Accessories – Accessoires – Accessorios – Acessórios Roller Attachment – 10 1/4″ (260 mm) Attachment à roulettes Accessorio para el rodillo Acessórios para o rolo (260 mm) 78-6969-7214-6 HA5760 Write-on Film Roll Rouleau de pellicule à écrire Rollo de Pelicula para Escribir Rolo e Película para Escrever 78-9020-1282-8 – 10 1/4 ″ (260mm) AF4310 Overhead Presenter’s Cart Chariot pour rétroprojecteur Carro para Presentación del Proyector Carro para o
Visual Systems Division Boulevard de liOise 95006 Cergy Pontoise Cedex France Printed in U.S.A.
