SDS

3M(TM) Bondo Fiberglass Resin for Fiberglass Resin Kit(s) 420, 420C, 420ES, 420K, 420T, 422, 422C
__________________________________________________________________________________________
Page: 5 of 10
Eye/face protection
Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Indirect Vented Goggles
Skin/hand protection
Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the
results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the
substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective
clothing. Note: Nitrile gloves may be worn over polymer laminate gloves to improve dexterity.
Gloves made from the following material(s) are recommended: Fluoroelastomer
Polyvinyl Alcohol (PVA)
Polymer laminate
Respiratory protection
An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part
of a full respiratory protection program. Based on the results of the exposure assessment, select from the following
respirator type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapours and particulates
For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state
Liquid
Specific Physical Form:
Paste
Appearance/Odour
Pungent organic odour. Light straw colour.
Odour threshold
No Data Available
pH
No Data Available
Melting point/Freezing point
No Data Available
Boiling point
82.2 ºC - 212.8 ºC
Flash Point
31.1 ºC [Test Method:Closed Cup]
Evaporation rate
No Data Available
Flammability (solid, gas)
Not Applicable
Flammable Limits(LEL)
1.1 %
Flammable Limits(UEL)
No Data Available
Vapour Pressure
460 Pa
Vapour Density
No Data Available
Density
1.14 g/ml
Relative density
1.14 [Ref Std:WATER=1]
Water solubility
Negligible
Solubility- non-water
No Data Available
Partition coefficient: n-octanol/ water
No Data Available
Autoignition temperature
No Data Available
Decomposition temperature
No Data Available
Viscosity
No Data Available
Volatile Organic Compounds
386 g/l [Test Method:calculated SCAQMD rule 443.1]
Volatile Organic Compounds
33.8 % weight [Test Method:calculated per CARB title 2]
Percent volatile
33.8 % weight
VOC Less H2O & Exempt Solvents
386 g/l [Test Method:calculated SCAQMD rule 443.1]