Owner Manual

Product Name:
Gray Cement Modern Column Outdoor Fountain with LED Light
SKU #:
Instruction Manual
Please save this manual for future reference.
Thank you for purchasing this . This product has been manufactured with the highest standards of safety and
quality.
PLEASE READ ALL INSTRUCTIONS BEFORE ASSEMBLY.
Unpack all parts from Styrofoam and bubble wrap inside the carton to ensure there are no missing or damaged
parts. If any parts are missing or damaged, do not attempt to assemble or use the product.
CARTON CONTENTS:
Description
Quantity
Fountain
1
Pump
1
LED Connector and Plug
1
C
ompatible Pumps for this fountain:
Pump Model No.
Tools required for assembly: No tools required for assembly.
Asse
mbly Instructions:
1. Unpack the contents of the box and check to make sure that all items are accounted for and in good
condition.
2. Select a flat, level surface for the assembly and final location of your fountain.
3. From the opening at the back of the fountain, insert the water supply tube into the pump outlet. Insert th
e
L
ED connector into the LED connector, and twist to tighten. Place the pump upright in the basin and draw
the pump power cord out of the fountain back.
4. Add clean water to the fountain. The water level should be approximately 30mm lower than the edge of the
basin.
5. Connect the power cables for the pump and the LED light to the outlet. If installed properly, water flow in
the fountain will begin shortly. Lights are turned on and off by plugging into an electrical outlet for on, and
removing the plug of the LED connection from the outlet for off.
6. Please do not use the electrical plug in wet weather conditions. Please note: On first use, there may be air in
the pump. It may take several minutes until all the air escapes.
7. To eliminate the possibility of water damage around your fountain, check for leaks and excessive splashing
after the initial setup of your fountain. It is highly recommended that this fountain be placed in an are
a
w
here it cannot be damaged.