flicks Quick Start Guide TURN ON THE MASTER SWITCH You won’t be able to operate Flicks without turning on the master switch located at the bottom of Flicks CHARGE YOUR FLICKS Fully charge your Flicks using the included power adapter before first use. It would take approximately 4 to 10 hours to fully charge your Flicks depending on the Flicks models you purchase.
LISTEN TO BLUETOOTH MUSIC ON FLICKS TURNING ON SPEAKER 1.Press and hold the speaker power button for 2 seconds to turn on the speakers. 2.Turn on Bluetooth on your Bluetooth-enabled device. 3.When prompted, select “Dashbon Flicks” to pair. It may take up to a minute to pair. ADJUSTING VOLUME Adjust the music volume by pressing the + and buttons located on the top panel of Flicks or the volume buttons on your Bluetooth-enabled device.
SAFETY The lightning flash with arrow-head symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the unit’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the unit.
WARNINGS • To reduce the risk of fire or electrical shock, do not expose the product to rain or moisture. • Do not expose this apparatus to dripping or splashing, and do not place objects filled with liquids, such as vases, on or near the apparatus. As with any electronic products, use care not to spill liquids into any part of the system. Liquids can cause a failure and/or a fire hazard. • Do not place any naked flame sources, such as lighted candles, on or near the apparatus.
IMPORTANT SAFETY INSTRUCTIONS 1. 2. 3. 4. 5. 6. 7. 8. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with a dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
19. Do not attempt to service the unit yourself. Opening or removing covers may expose you to dangerous voltages or other hazards. The unit should only be repaired by appropriate service personnel, please contact Dashbon Customer Service. 20. Do not look directly into projector beam.
IC WARNING STATEMENT This device complies with Industry Canada License-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
radio frequency exposure limits. The Wireless Device should be used in such a manner such that the potential for human contact during normal operation is minimized. This device has also been evaluated and shown compliant with the IC RF Exposure limits under mobile exposure conditions. (Antennas are greater than 20cm from a person’s body). Avertissement d’Industrie Canada Cet appareil est conforme à la norme d’Industrie Canada sur les appareils radio exempts de licence.
Article 14 The application of low power frequency electric machineries shall not affect the navigation safety nor interfere a legal communication, if an interference is found, the service will be suspended until improvement is made and the interference no longer exists.