Quick Installation Guide

11.6” Touch Panel
Quick Installation Guide
Consult the dealer or contact [e-mail] for help
Symphony XL
English V1.1
Device - Overview
Planning the installation
The device is designed to be wall mounted in either Portrait or Landscape
orientation, or on tabletop with stand.
The device requires a minimum mounting depth of 1”(2.45cm) from the wall
surface to the room for cable/s. Power may be supplied by Power Over
Ethernet (PoE) or by a 24V DC power supply (not included). PoE connecting
must meets the IEEE 802.3af standard. Direct power connecting via a 24V DC
external power supply requires a minimum current output of 1A. The device
connects to the local network via a hard wired Ethernet connection.
Or connecting with WiFi in the case of the units with WiFi function.
Installing the device
A. Mounting height
The recommended mounting height
for the device is 57”- 65”
(145 cm -165 cm) from the finished
floor to the center of the unit.
B. Landscape/Portrait mounting
Device can be mounted and oriented in Portrait or Landscape.
165 cm / 65”
145 cm / 57”
Camera
Speaker
Light Sensor
Speaker
Microphone
LAN + Power
over Ethernet
USB
Hue Lights Hue Lights
DC Power Input
Included in the box
�1ea Device
�1ea Mounting bracket
�4ea Mounting screws
Introduction
To install the device you will also need one of the following electrical junction
boxes or low-voltage brackets.
Important safety instructions
Read, understand and follow ALL safety and installation instructions included
in this manual. Failure to follow the included documentation may damage the
product and will void the manufacturer’s warranty. Follow ALL installation
guidelines included with the product. Installation of the product in high
humidity environments, in close proximity to heat sources and/or
non-recommended locations WILL impede, interfere and/or damage the
intended operation of the product. Only use attachments and accessories
which have been specified for use by the manufacturer. The use of abrasive,
liquid or solvent-based cleaning fluids WILL damage the product. Product
Servicing may ONLY be completed by authorized or certified service centers &
personnel. For a complete list of product servicing options, please follow
instructions included in the product documentation and/or contact the original
manufacturer for details.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
On the wall On the stand
Part No.:89-123-1030A1F
Standard NEMA
2-gang US electrical
junction box
Low-voltage mounting ring
Arlington LV2 (Bracket
supplied in the box)
UK standard 2-gang
electrical box
European/Italian
16204 muiltibox
Note:Only Symphony XL equipped with hue lights.